Description
FRC FROG-D Single Phase Generator
The FROG-D is a digital device that can be used to monitor 120 or 240 volt single phase generators rated from 6 to 45 kW. The small, waterproof, digital display shows Frequency (in Hertz) accurate to 1 decimal point, Current (in Amps) on two separate lines, and Voltage (in Volts AC).
The FROG-D is more than just a display, it also functions as a Warning System. It constantly monitors inputs and provides a visual warning alarm when a value goes out of normal range. An output is available to connect an optional audible alarm.
Accumulated generator operating hours are stored in a non-eraseable memory.
The FROG-D is a display only version of the FROG governor and is for use with PTO driven generators that have built in governing capabilities. If the generator does not have a built in governor, FRC offers the same displays on the standard FROG Generator Governor. Refer to the FROG Governor page for more information.
The FROG D 3-Phase is available for 120 or 240 volt three phase systems with both delta and star windings. Refer to the FROG D 3-Phase Delta or Star page for more information.
- Displays frequency, voltage, and current
- Ideal for hydraulic, diesel powered, and PTO generators
- Rated for 50/60 Hz generators from 6 to 45 kW
- Highly visibile ultra-bright LEDs
- MODE button displays total generator Hrs. and Hydraulic Oil temp.
- Optional hydraulic oil temperature sensor and audible alarm buzzer
The three phase signal interface module is mounted close to the current sensors and voltage transformaers so that cable runs are short.
Current and voltage information is passed to the display module over a two-wire datalink.
Details
SKU: |
FRC-FDA100 |